Refine
Year of publication
- 2021 (2)
Document Type
- Article (2)
Language
- English (2)
Has Fulltext
- yes (2)
Is part of the Bibliography
- yes (2)
Institute
- Fakultät IuI (2)
Fatigue Improvement of AlSi10Mg Fabricated by Laser-Based Powder Bed Fusion through Heat Treatment
(2021)
This study aimed to identify an optimal heat-treatment parameter set for an additively manufactured AlSi10Mg alloy in terms of increasing the hardness and eliminating the anisotropic microstructural characteristics of the alloy in as-built condition. Furthermore, the influence of these optimized parameters on the fatigue properties of the alloy was investigated. In this respect, microstructural characteristics of an AlSi10Mg alloy manufactured by laser-based powder bed fusion in non-heat-treated and heat-treated conditions were investigated. Their static and dynamic mechanical properties were evaluated, and fatigue behavior was explained by a detailed examination of fracture surfaces. The majority of the microstructure in the non-heat-treated condition was composed of columnar grains oriented parallel to the build direction. Further analysis revealed a high fraction of pro-eutectic α-Al. Through heat treatment, the alloy was successfully brought to its peak-hardened condition, while eliminating the anisotropic microstructural features. Yield strength and ductility increased simultaneously after heat treatment, which is due to the relief of residual stresses, preservation of refined grains, and introduction of precipitation strengthening. The fatigue strength, calculated at 107 cycles, improved as well after heat treatment, and finally, detailed fractography revealed that a more ductile fracture mechanism occurred in the heat-treated condition compared to the non-heat-treated condition.
In this experimental work, the quasi static and fatigue properties of a 40 wt.% long carbon fiber reinforced partially aromatic polyamide (Grivory GCL-4H) were investigated. For this purpose, microstructural parameter variations in the form of different thicknesses and different removal directions from injectionmolded plates were evaluated. Mechanical properties decreased by increasing misalignment away from the melt flow direction. By changing the specimen thickness, no change in the general fiber distribution pattern transversal and normal to the axis of melt flow was observed. It has shown that with increasing specimen thickness the quasi static properties along the melt flow direction decreased and vice versa resulting in superior properties normal to the melt flow axis. At around 5 mm, an intersection suggests quasi-isotropic behavior. In addition, the fatigue strength of the material was significantly higher in the flow direction than normal to the flow direction. No change in fatigue life was observed while changing specimen thickness. The Basquin equation seems to describe the effect of stress amplitude on the fatigue strength of this composite. Scanning electron microscopy was used to investigate fracture surfaces of tested specimens. Results show that mechanical properties and morphological structures depend highly on fiber orientation.