580 Pflanzen (Botanik)
Refine
Year of publication
Document Type
- Article (50)
- Conference Proceeding (41)
- Part of a Book (8)
- Book (5)
- Master's Thesis (3)
- Working Paper (3)
- Report (2)
- Bachelor Thesis (1)
- Doctoral Thesis (1)
- Other (1)
Keywords
- Dendrologie (4)
- selenium (4)
- Biodiversity (2)
- Hay transfer (2)
- Secondary succession (2)
- Seeding (2)
- Stadtbäume (2)
- agronomic biofortification (2)
- apple (2)
- biofortification (2)
Institute
- Fakultät AuL (112)
- Fakultät IuI (1)
- Präsidium Hochschule Osnabrück (1)
The impact of pulsed light (PL) treatment on naturally occurring microorganisms, mycotoxins, and on physicochemical properties in red pepper powder was investigated. Powder samples were exposed to different PL treatments up to 61 pulses, with fluence ranging from 1.0 to 9.1 J/cm2. The highest fluence applied (9.1 J/cm2, 61 pulses, 20 s) resulted in 2.7, 3.1, and 4.1 log CFU/g reduction of yeasts, molds, and total plate counts (TPC), where initial microbial loads were 4.6, 5.5, and 6.5 log CFU/g, respectively. At the same fluence intensity, a maximum reduction of 67.2, 50.9, and 36.9% of aflatoxin B1 (AFB1), total aflatoxins (AF), and ochratoxin A (OTA) were detected, respectively. Proportional increase in temperature of the samples was observed from the absorbed PL energy, reaching maximum of 59.8°C. The inactivation of investigated microorganisms and mycotoxins followed first-order kinetics (R2 > 0.95). The fluence intensity at 6.9 and 9.1 J/cm2 did not cause degradation, but rather a significant (p < .05) and apparent increase of total phenols. Total color difference (ΔE*) revealed only “slight differences,” compared to the untreated sample. In conclusion, higher reduction of microbial load and mycotoxins in red pepper powder could be achieved, when higher treatment intensity was applied. This suggests the PL as a potential technology for decontamination of red pepper powder and other spice powders.
The kiwifruit processing industry is focused on product yield maximization and keeping energy costs and waste effluents to a minimum while maintaining high product quality. In our study, pulsed electric field (PEF) pretreatment enhanced kiwifruit processing to facilitate peelability and specific peeling process and enhanced valorization of kiwifruit waste. PEF optimization was applied to obtain the best treatment parameters. A 32 factorial design of response surface methodology was applied to find the effect of time elapsed after PEF treatment and the PEF-specific energy input on specific peeling force and kiwifruit firmness as response criteria. Under the optimized condition, the specific peeling force decreased by 100, and peelability increased by 2 times. The phenolic content and antioxidant capacity of PEF-treated kiwifruit bagasse were 5.1% and 260% richer than the control sample. Overall, the optimized PEF pretreatments incorporated into kiwifruit processing led to decreased energy demand and increased productivity.
Response of petunia to wood fibre amended peat substrate under ebb-and-flow irrigation (Abstract)
(2024)
Test von Schnellverfahren zur Bestimmung der Benetzungseigenschaften von Kultursubstraten (Abstract)
(2024)
Enhancing the nutritional value of pears through agronomic biofortification with iodine (Abstract)
(2024)
Water retention properties of wood fiber based growing media and their impact on irrigation strategy
(2024)
Distribution of water and air in growing media during ebb-and-flow irrigation depends on water storage properties (water retention curve) and water transport properties (hydraulic conductivity) of the materials. Growing media with their high number of coarse pores are known to exhibit strong hysteresis, i.e., differences in the water retention properties during drying and wetting cycles. To account for potential ecological disadvantages of peat, wood fibers are commonly used as substitutes for peat in growing media. However, the wood fibers generally have higher air capacities and hydraulic conductivities and lower water capacities compared to peat which may results in necessary adaptions of the irrigation strategy. Tools to optimize irrigation systems are physically based water transport models, such as HYDRUS-1D, which is commonly used to describe water transport in soils, but not often for growing media. In this study, white peat and pure wood fibers were used to describe differences in their water retention behavior. Water retention curves (drying cycles) and hydraulic conductivities were measured with standard analytical procedures. Hysteresis of the water retention curves was analytically determined based on their capillary rise properties. The results were used with a modified HYDRUS-1D model to test model quality against measured water contents during ebb-and-flow irrigation cycles and to optimize the irrigation strategy for the different materials. The results showed that the model quality was sufficiently good only if the strong hysteresis of the water retention curves was considered during the simulation process. Different strategies were tested to modify ebb-and-flow irrigation (irrigation frequency, irrigation duration and irrigation height) in that way that the water suction in the root zone was similar to that of the peat material. Simulation results showed that significant improvements could only be reached by increasing the flooding depth in ebb-and-flow systems to ensure an optimum water supply of plants in the wood fiber based growing media.