Refine
Year of publication
Document Type
- Conference Proceeding (47)
- Article (16)
- Part of a Book (3)
Has Fulltext
- no (66) (remove)
Is part of the Bibliography
- yes (66)
Keywords
- agronomic biofortification (2)
- foliar sprays (2)
- nitrate (2)
- selenium (2)
- 3,4-Dimethylpyrazole phosphate (1)
- Ammonium/Nitrat-Verhältnis (1)
- Ammoniumtoxizität (1)
- Balance sheet (1)
- Base fertilization (1)
- Biofortification (1)
Institute
- Fakultät AuL (65)
Enhancing the nutritional value of pears through agronomic biofortification with iodine (Abstract)
(2024)
The development of base metal electrodes that can act as active and stable oxygen generating electrodes in water electrolysis systems, especially at low pH levels, remains a challenge. The use of suspensions as electrolytes for water splitting has until recently been limited to photoelectrocatalytic approaches. A high current density (j=30 mA/cm2) for water electrolysis has been achieved at a very low oxygen evolution reaction (OER) potential (E=1.36 V vs. RHE) using a SnO2/H2SO4 suspension-based electrolyte in combination with a steel anode. More importantly, the high charge-to-oxygen conversion rate (Faraday efficiency of 88% for OER at j=10 mA/cm2 current density). Since cyclic voltammetry (CV) experiments show that oxygen evolution starts at a low, but not exceptionally low, potential, the reason for the low potential in chronoamperometry (CP) tests is an increase in the active electrode area, which has been confirmed by various experiments. For the first time, the addition of a relatively small amount of solids to a clear electrolyte has been shown to significantly reduce the overpotential of the OER in water electrolysis down to the 100 mV region, resulting in a remarkable reduction in anode wear while maintaining a high current density.
Water retention properties of wood fiber based growing media and their impact on irrigation strategy
(2024)
Distribution of water and air in growing media during ebb-and-flow irrigation depends on water storage properties (water retention curve) and water transport properties (hydraulic conductivity) of the materials. Growing media with their high number of coarse pores are known to exhibit strong hysteresis, i.e., differences in the water retention properties during drying and wetting cycles. To account for potential ecological disadvantages of peat, wood fibers are commonly used as substitutes for peat in growing media. However, the wood fibers generally have higher air capacities and hydraulic conductivities and lower water capacities compared to peat which may results in necessary adaptions of the irrigation strategy. Tools to optimize irrigation systems are physically based water transport models, such as HYDRUS-1D, which is commonly used to describe water transport in soils, but not often for growing media. In this study, white peat and pure wood fibers were used to describe differences in their water retention behavior. Water retention curves (drying cycles) and hydraulic conductivities were measured with standard analytical procedures. Hysteresis of the water retention curves was analytically determined based on their capillary rise properties. The results were used with a modified HYDRUS-1D model to test model quality against measured water contents during ebb-and-flow irrigation cycles and to optimize the irrigation strategy for the different materials. The results showed that the model quality was sufficiently good only if the strong hysteresis of the water retention curves was considered during the simulation process. Different strategies were tested to modify ebb-and-flow irrigation (irrigation frequency, irrigation duration and irrigation height) in that way that the water suction in the root zone was similar to that of the peat material. Simulation results showed that significant improvements could only be reached by increasing the flooding depth in ebb-and-flow systems to ensure an optimum water supply of plants in the wood fiber based growing media.
Wood fibers can contribute to replacing peat in growing media and thus help to protect peatlands. As domestic, renewable raw materials, they represent a sustainable option for this purpose. To date, however, wood fibers are usually used as a peat substitute at a maxi-mum of 30% (v/v). A main reason for this limitation is the insufficient microbial stability of wood fibers, which favors nitrogen immobilization and can thus impair nitrogen supply of plants. To address this drawback, in this study wood fibers were subjected to different thermal or thermal-hydrolytic treatments. Seedling tests with napa cabbage were conducted to determine whether treated wood fibers were free of phytotoxic substances. Mixtures with 50% (v/v) wood fiber and white peat each were used. In addition, three wood fiber varieties were evaluated in the cultivation of petunia. Two wood fiber proportions (30 and 60% v/v) and two nitrogen fertilization rates (common and increased supply) were included in each case. In the seedling trial with napa cabbage, no phytotoxic effects were detectable in any of the wood fiber variants investigated. However, when cultivating petunias, both shoot mass growth and number of flowers decreased with increasing wood fiber content. In substrates with a wood fiber content of 60% (v/v), plant development was inhibited so severely that the petunias no longer achieved marketable quality. Increased nitrogen fertilization was able to compensate for this negative effect only in few cases. This suggests that other factors than nitrogen limited plant growth in wood fiber-rich substrates. Among others, physical proper-ties such as the lower water capacity of wood fibers may be a cause. More in-depth investigations are still required in this regard.
Boron dynamics in a peat-based growing medium and its impact on the growth of basil (Abstract)
(2021)
As allergy towards apples is widespread, the evaluation of various cultivation and postharvest influences on the allergenic potential is of great importance. Therefore, the analysis of the Mal d 1 content was the focus of this study, originally dealing with investigating the influence of a selenium biofortification on apple quality. The Mal d 1 content of apples was in most cases reduced when the fruits were biofortified with selenium. Apple variety and climatic conditions were identified as further influencing factors for the Mal d 1 content of the fruits. The separate analysis of the peel and the fruit flesh showed that the content of Mal d 1 in the fruit flesh was significantly lower in the biofortified samples than in the controls. In conclusion, the results indicate that the selenium biofortification of apples and biochemical mechanism behind can reduce the allergenic potential regarding the content of Mal d 1.
Perceptions of German consumers regarding methods for fortifying foods with iodine (Abstract)
(2022)
Aus dem Brutschrank ins Gewächshaus – Bewertung des Stickstoffhaushalts in Substraten (Abstract)
(2022)
Einfluss einer Selen-Biofortifikation auf verschiedene Qualitätsparameter von Äpfeln (Abstract)
(2022)
Spinach is a nitrogen (N)-demanding crop characterized by a shallow root architecture. Especially in the first weeks after sowing, significant N uptake is limited to the uppermost few centimetres of the soil. However, base fertilization is usually based on the soil mineral N (Nmin) concentration in the upper 30 cm. Therefore, the objective of this study was to examine whether the soil sample depth for calculating the base N fertilization can be reduced to the 0-15 cm layer. In seven field trials, conducted during spring, summer and autumn seasons, either a low or high base fertilization dose was applied at sowing. Until top dressing, soil samples were frequently taken in the upper 0-15 and 15-30 cm layers to determine the average Nmin concentration in each layer. Top dressing was applied when the first true leaves had unfurled. With this fertilizer application, the total N supply was aligned between both treatments based on the Nmin concentration in the upper 30 cm of the soil. Aboveground fresh and dry masses were determined after reaching a fresh mass yield of 15-20 t ha‑1 and related to the mean Nmin concentration in the first 3 to 4 weeks of cultivation between sowing and top dressing. It was shown that the Nmin concentration in the upper 0-15 cm of the soil highly reflects the base fertilization rate. By contrast, the Nmin concentration in the 15-30 cm layer remained unaffected. However, the Nmin concentration of both top soil layers can affect fresh and dry mass yield at harvest. Therefore, the entire 0-30 cm soil layer should be considered when calculating the base N fertilization rate in field-grown spinach. Measurements revealed that spinach fresh and dry masses were increased until the N availability of between 54 and 59 kg ha‑1 (0-30 cm) was reached at the seedlings stage, respectively.