Refine
Year of publication
Document Type
- Conference Proceeding (61)
- Article (23)
- Part of a Book (3)
Is part of the Bibliography
- yes (87)
Keywords
- selenium (4)
- agronomic biofortification (2)
- apple (2)
- biofortification (2)
- foliar sprays (2)
- nitrate (2)
- phenolic compounds (2)
- 3,4-Dimethylpyrazole phosphate (1)
- Ammonium/Nitrat-Verhältnis (1)
- Ammoniumtoxizität (1)
Institute
- Fakultät AuL (87) (remove)
Water retention properties of wood fiber based growing media and their impact on irrigation strategy
(2024)
Distribution of water and air in growing media during ebb-and-flow irrigation depends on water storage properties (water retention curve) and water transport properties (hydraulic conductivity) of the materials. Growing media with their high number of coarse pores are known to exhibit strong hysteresis, i.e., differences in the water retention properties during drying and wetting cycles. To account for potential ecological disadvantages of peat, wood fibers are commonly used as substitutes for peat in growing media. However, the wood fibers generally have higher air capacities and hydraulic conductivities and lower water capacities compared to peat which may results in necessary adaptions of the irrigation strategy. Tools to optimize irrigation systems are physically based water transport models, such as HYDRUS-1D, which is commonly used to describe water transport in soils, but not often for growing media. In this study, white peat and pure wood fibers were used to describe differences in their water retention behavior. Water retention curves (drying cycles) and hydraulic conductivities were measured with standard analytical procedures. Hysteresis of the water retention curves was analytically determined based on their capillary rise properties. The results were used with a modified HYDRUS-1D model to test model quality against measured water contents during ebb-and-flow irrigation cycles and to optimize the irrigation strategy for the different materials. The results showed that the model quality was sufficiently good only if the strong hysteresis of the water retention curves was considered during the simulation process. Different strategies were tested to modify ebb-and-flow irrigation (irrigation frequency, irrigation duration and irrigation height) in that way that the water suction in the root zone was similar to that of the peat material. Simulation results showed that significant improvements could only be reached by increasing the flooding depth in ebb-and-flow systems to ensure an optimum water supply of plants in the wood fiber based growing media.
Iron deficiency is still widespread as a major health problem even in countries with adequate food supply. It mainly affects women but also vegans, vegetarians, and athletes and can lead to various clinical pictures. Biofortification of vitamin C-rich vegetables with iron may be one new approach to face this nutritional challenge. However, so far, little is known about the consumer acceptance of iron-biofortified vegetables, particularly in developed countries. To address this issue, a quantitative survey of 1000 consumers in Germany was conducted. The results showed that depending on the type of vegetable, between 54% and 79% of the respondents were interested in iron-biofortified vegetables. Regression analysis showed a relationship between product acceptance, gender, and area of residence. In addition, relationships were found between consumer preferences for enjoyment, sustainability, and naturalness. Compared to functional food and dietary supplements, 77% of respondents would prefer fresh iron-rich vegetables to improve their iron intake. For a market launch, those iron-rich vegetables appear especially promising, which can additionally be advertised with claims for being rich in vitamin C and cultivated in an environmentally friendly way. Consumers were willing to pay EUR 0.10 to EUR 0.20 more for the iron-biofortified vegetables.
The development of base metal electrodes that can act as active and stable oxygen generating electrodes in water electrolysis systems, especially at low pH levels, remains a challenge. The use of suspensions as electrolytes for water splitting has until recently been limited to photoelectrocatalytic approaches. A high current density (j=30 mA/cm2) for water electrolysis has been achieved at a very low oxygen evolution reaction (OER) potential (E=1.36 V vs. RHE) using a SnO2/H2SO4 suspension-based electrolyte in combination with a steel anode. More importantly, the high charge-to-oxygen conversion rate (Faraday efficiency of 88% for OER at j=10 mA/cm2 current density). Since cyclic voltammetry (CV) experiments show that oxygen evolution starts at a low, but not exceptionally low, potential, the reason for the low potential in chronoamperometry (CP) tests is an increase in the active electrode area, which has been confirmed by various experiments. For the first time, the addition of a relatively small amount of solids to a clear electrolyte has been shown to significantly reduce the overpotential of the OER in water electrolysis down to the 100 mV region, resulting in a remarkable reduction in anode wear while maintaining a high current density.
Test von Schnellverfahren zur Bestimmung der Benetzungseigenschaften von Kultursubstraten (Abstract)
(2024)
Stainless steel made to rust: a robust water-splitting catalyst with benchmark characteristics
(2015)
The oxygen evolution reaction (OER) is known as the efficiency-limiting step for the electrochemical cleavage of water mainly due to the large overpotentials commonly used materials on the anode side cause. Since Ni–Fe oxides reduce overpotentials occurring in the OER dramatically they are regarded as anode materials of choice for the electrocatalytically driven water-splitting reaction. We herewith show that a straightforward surface modification carried out with AISI 304, a general purpose austenitic stainless steel, very likely, based upon a dissolution mechanism, to result in the formation of an ultra-thin layer consisting of Ni, Fe oxide with a purity >99%. The Ni enriched thin layer firmly attached to the steel substrate is responsible for the unusual highly efficient anodic conversion of water into oxygen as demonstrated by the low overpotential of 212 mV at 12 mA cm−2 current density in 1 M KOH, 269.2 mV at 10 mA cm−2 current density in 0.1 M KOH respectively. The Ni, Fe-oxide layer formed on the steel creates a stable outer sphere, and the surface oxidized steel samples proved to be inert against longer operating times (>150 ks) in alkaline medium. In addition Faradaic efficiency measurements performed through chronopotentiometry revealed a charge to oxygen conversion close to 100%, thus underpinning the conclusion that no “inner oxidation” based on further oxidation of the metal matrix below the oxide layer occurs. These key figures achieved with an almost unrivalled-inexpensive and unrivalled-accessible material, are among the best ever presented activity characteristics for the anodic water-splitting reaction at pH 13.
Soil versus foliar iodine fertilization as a biofortification strategy for field-grown vegetables
(2015)
Iodine (I) biofortification of vegetables by means of soil and foliar applications was investigated in field experiments on a sandy loam soil. Supply of iodine to the soil in trial plots fertilized with potassium iodide (KI) and potassium iodate directly before planting (0, 1.0, 2.5, 7.5, and 15 kg I ha-1) increased the iodine concentration in the edible plant parts. The highest iodine accumulation levels were observed in the first growing season: In butterhead lettuce and kohlrabi the desired iodine content [50–100 μg I (100 g FM)-1] was obtained or exceeded at a fertilizer rate of 7.5 kg IO3--I ha-1 without a significant yield reduction or impairment of the marketable quality. In contrast, supplying KI at the same rate resulted in a much lower iodine enrichment and clearly visible growth impairment. Soil applied iodine was phytoavailable only for a short period of time as indicated by a rapid decline of CaCl2-extractable iodine in the top soil. Consequently, long-term effects of a one-time iodine soil fertilization could not be observed. A comparison between the soil and the foliar fertilization revealed a better performance of iodine applied aerially to butterhead lettuce, which reached the desired iodine accumulation in edible plant parts at a fertilizer rate of 0.5 kg I--I ha-1. In contrast, the iodine content in the tuber of sprayed kohlrabi remained far below the targeted range. The results indicate that a sufficient spreading of iodine applied on the edible plant parts is crucial for the efficiency of the foliar approach and leafy vegetables are the more suitable target crops. The low iodine doses needed as well as the easy and inexpensive application may favor the implementation of foliar sprays as the preferred iodine biofortification strategy in practice.
Spinach is a nitrogen (N)-demanding crop characterized by a shallow root architecture. Especially in the first weeks after sowing, significant N uptake is limited to the uppermost few centimetres of the soil. However, base fertilization is usually based on the soil mineral N (Nmin) concentration in the upper 30 cm. Therefore, the objective of this study was to examine whether the soil sample depth for calculating the base N fertilization can be reduced to the 0-15 cm layer. In seven field trials, conducted during spring, summer and autumn seasons, either a low or high base fertilization dose was applied at sowing. Until top dressing, soil samples were frequently taken in the upper 0-15 and 15-30 cm layers to determine the average Nmin concentration in each layer. Top dressing was applied when the first true leaves had unfurled. With this fertilizer application, the total N supply was aligned between both treatments based on the Nmin concentration in the upper 30 cm of the soil. Aboveground fresh and dry masses were determined after reaching a fresh mass yield of 15-20 t ha‑1 and related to the mean Nmin concentration in the first 3 to 4 weeks of cultivation between sowing and top dressing. It was shown that the Nmin concentration in the upper 0-15 cm of the soil highly reflects the base fertilization rate. By contrast, the Nmin concentration in the 15-30 cm layer remained unaffected. However, the Nmin concentration of both top soil layers can affect fresh and dry mass yield at harvest. Therefore, the entire 0-30 cm soil layer should be considered when calculating the base N fertilization rate in field-grown spinach. Measurements revealed that spinach fresh and dry masses were increased until the N availability of between 54 and 59 kg ha‑1 (0-30 cm) was reached at the seedlings stage, respectively.
As allergy towards apples is widespread, the evaluation of various cultivation and postharvest influences on the allergenic potential is of great importance. Therefore, the analysis of the Mal d 1 content was the focus of this study, originally dealing with investigating the influence of a selenium biofortification on apple quality. The Mal d 1 content of apples was in most cases reduced when the fruits were biofortified with selenium. Apple variety and climatic conditions were identified as further influencing factors for the Mal d 1 content of the fruits. The separate analysis of the peel and the fruit flesh showed that the content of Mal d 1 in the fruit flesh was significantly lower in the biofortified samples than in the controls. In conclusion, the results indicate that the selenium biofortification of apples and biochemical mechanism behind can reduce the allergenic potential regarding the content of Mal d 1.